19179794 - Clip Riparazione DTC C0710

Part Number 19179794
Codici alternativi
Sostituisce

Scheda tecnica 19179794

Descrizione

Clip per fissaggio connettore che causa il DTC C0710


#06-02-35-002B: Stabilitrak/Active Handling Light On, Service Stabilitrak/Active Handling Message on DIC, DTC C0710 Steering Wheel Position Sensor (SWPS) Signal Set (Install Clip in SWPS Connector) - (Oct 19, 2007)


Subject: Stabilitrak/Active Handling Light On, Service Stabilitrak/Active Handling Message on DIC, DTC C0710 Steering Wheel Position Sensor (SWPS) Signal Set (Install Clip in SWPS Connector)

Models: 2008 Buick Lucerne

2004-2008 Cadillac XLR

2006-2008 Cadillac DTS

2005-2008 Chevrolet Corvette

with Steering Wheel - Tilt, Telescoping (RPO N37 or N38)
--------------------------------------------------------------------------------
This bulletin is being revised to update the models and provide new correction information. Please discard Corporate Bulletin Number 06-02-35-002A (Section 02 -- Steering).
--------------------------------------------------------------------------------
Condition
Some customers may comment on a Stabilitrak® or Active Handling System light being illuminated. Also, this warning light will be accompanied by a SERVICE STABILITRAK or SERVICE ACTIVE HNDLG message on the DIC.

Diagnosis with a scan tool may reveal a DTC C0710.

Cause
The most likely cause of a DTC C0710 on a vehicle equipped with telescoping/tilt steering wheel is high resistance in SWPS connector C202. Fretting terminal corrosion may be present in the SWPS connector due to the telescoping motion of the steering column. When the steering column is telescoped in and out, the female terminals within the SWPS connector may move on the male terminals of the SWPS. This movement between the terminals may cause a high resistance condition in the SWPS connector.

Correction
Remove the driver's side closeout (insulator) panel.
Locate the SWPS connector that connects to the steering angle sensor, located on the lower center of the steering column.

Install the clip (1), P/N 19179794, into the connector. This clip will act as a terminal positive assurance (TPA) and prevent any movement of the terminals.
Reinstall the closeout panel.
Clear the DTC with a scan tool and road test the vehicle.
If DTC C0710 resets during the road test, refer to DTC C0710 in SI.


Again the sequence is the message telling you something is wrong, then read codes with scanner that can read ABS codes (an OBD II scanner will not do it), once you have the code look up the diagnostic procedure and follow it to the best of your ability including coming up with work arounds for any Tech II command capabilities that are used in the procedure.

Short circuit this process and you are wandering around in the woods, in the dark with a bag over your head and hoping you will find your way home.

Produttore GM PARTS
Peso n.d
Pezzi per confezione 1
Prezzo 6,99 €  (IVA esclusa)
Ultimo aggiornamento 24/10/2012


19179794
6,99 €
(IVA esclusa)
Disponibile Disponibile
Il prodotto è disponibile a listino, giacenza da verificare.

Spedizioni in tutta Italia e mondo

Richiedi questo articolo

* Campi obbligatori
No Si